ASP Flying Model Rocket Kit Way Two High! ASP KWTH-18/24
Easy to build 2-stage kit! Booster section can be built in either of two styles (as shown in the picture). Laser-Cut balsa fins, payload section (large enough to accommodate most commercial altimeters) and balsa wood nose cone. Can be built for either 18 mm or 24 mm engines. Fun, way high flyer for the new or the experienced modeler! Great model to learn basic rocketry modeling and staging.
Ideal if you're following the NAR NARTREK program!
Specifications:
Length: 24.75"(62.87mm)
Diameter: 0.976"(24.8mm)
Approx. Weight: 2oz(57g)
Recovery Device: Streamer
Skill Level: Beginner/Intermediate
Recommended Engines (18mm Version):
Single Stage Flights: A8-3; B6-4; C6-5; C6-7
Two Stage Flights: Booster Engines: C6-0; Upper Stage Engines: A6-4; B6-4; B6-6; C6-7
Recommended Engines (24mm Version):
Single Stage Flights: C11-7; D12-5; D12-7; E9-6; E9-8
Two Stage Flights: Booster Engines: C11-0; D12-0; Upper Stage Engines: C11-7; D12-7; E9-8
What you'll need to build this model:
Required: Adhesive (A wood glue, such as Elmer's Carpenters Glue, eBond or Titebond can be used for all steps and is recommended.); sandpaper (medium - 220 or 280, fine - 320 or 400, & [optionally] extra fine - 500 or 600); pencil or ball point pen; scissors; cotton swab (“Q-Tip”, or piece of scrap balsa wood); hobby knife with a sharp #11 blade; scotch tape; sanding sealer (or balsa filler coat); thinner (appropriate type for the sanding sealer); small paint brush; paint (Spray paint, such as Krylon, Pactra or Tamiya is recommended. Be sure not to mix different types or brands of paint without testing.) - primer (optional), colors as desired & clear (optional).
Optional: filler material (such as Elmer’s Fill & Finish, Elmer’s Professional Carpenter’s Wood Filler or interior spackling paste); sanding block; tack cloth.
What you'll need to fly this model:
Electronic launch system; launch pad with 1/8" launch rod; recovery wadding; engines (see list of recommended engines above).
Made in the USA